Document Center is acquired by Nimonik

Scope

1.1 This practice is for the determination of total sulfur from volatile sulfur-containing compounds in high methane or hydrogen content gaseous fuels using on-line/at-line instrumentation.

1.2 The values stated in SI units are standard. Values stated in other units are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

On-line, at-line, in-line and other near-real time monitoring systems that measure fuel gas characteristics such as the total sulfur content are prevalent in the natural gas and fuel gas industries. The installation and operation of particular systems vary on the specific objectives, contractual obligations, process type, regulatory requirements, and internal performance requirements needed by the user. This protocol is intended to provide guidelines for standardized start-up procedures, operating procedures, and quality assurance practices for on-line, at-line, in-line and other near-real time total sulfur monitoring systems.

Keywords

at-line monitor, continuous fuel monitor, on-line monitor, total sulfur

To find similar documents by ASTM Volume:

05.06 (Gaseous Fuels; Coal and Coke)

To find similar documents by classification:

75.160.30 (Gaseous fuels Including liquefied petroleum gases Hydrogen, see 71.100.20 Natural gas, see 75.060)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.