ASTM-D7174 › Standard Specification for Preformed Closed-Cell Polyolefin Expansion Joint Fillers for Concrete Paving and Structural Construction
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers preformed expansion joint fillers made from closed-cell polyolefin materials having suitable compressibility and nonextruding characteristics.
1.1.1 Type I, closed-cell polyethylene or blended polyethylene.
1.2 These joint fillers are intended for use in concrete pavements in full-depth joints. There are several variations in size. A typical size measures 0.5-in. (12.7-mm) in thickness, 4.0-in. (101.6-mm) in width, and 10-ft (3.048-m) in length and will relieve stress or avoid potential distress in adjacent structures or pavements.
1.3 The values stated in inch-pound units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
cellular plastic; closed-cell; expansion joint; filler; joint; polyethylene; polyolefin; preformed; ICS Number Code 91.100.30 (Concrete and concrete products)
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
91.100.30 (Concrete and concrete products Including admixtures)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D7174-05R22
Revision Level
2005 R22 EDITION
Status
Current
Modification Type
New
Publication Date
June 6, 2022
Document Type
Specification
Page Count
2 pages
Committee Number
D04.34