Document Center is acquired by Nimonik

Scope

1.1 This test method covers the measurement of the molding index of thermosetting plastics ranging in flow from soft to stiff by selection of appropriate molding pressures within the range from 4.1 to 31.9 MPa.

1.2 The values stated in SI units are to be regarded as standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method provides a guide for evaluating the moldability of thermosetting molding powders. This test method does not necessarily denote that the molding behavior of different materials will be alike and trials may be necessary to establish the appropriate molding index for each material in question.

The sensitivity of this test diminishes when the molding pressure is decreased below 66 MPa, so pressures lower than this are not ordinarily recommended. This is due to the friction of moving parts and the insensitivity of the pressure switch actuating the timer at these low pressures.

Keywords

molding index; thermosets; ICS Number Code 83.080.10 (Thermosetting materials)

To find similar documents by ASTM Volume:

08.01 (Plastics (I): D256 - D3159)

To find similar documents by classification:

83.080.10 (Thermosetting materials Including ebonite Silicones, see 71.100.55)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.