Document Center is acquired by Nimonik

1.1 This practice describes procedures for full scale testing of structural glued laminated timber (glulam) to determine or verify characteristic values used to calculate flexural design properties. Guidelines are given for: (1) testing individual structural glued laminated timber lay-ups (with no modeling), (2) testing individual glulam combinations (with limited modeling), and (3) validating models used to predict characteristic values.

1.2 This practice is limited to procedures for establishing flexural properties (Modulus of Rupture, MOR, and Modulus of Elasticity, MOE). Some of the principles for sampling and analysis presented may be applicable to other properties. However, other properties may require additional testing considerations that are beyond the scope of this practice.

1.3 This practice is not intended to supersede the provisions of Practice D3737, but provides an alternative method for establishing characteristic values. Lay-up combinations developed in accordance with Practice D3737 are not required to be governed by this standard.

1.4 Details of production, inspection, and certification are beyond the scope of this document. However, for test results to be representative of production, quality control systems shall be in place to ensure consistent quality. Manufacturing shall conform to recognized manufacturing standards such as ANSI A190.1 or CSA O122.

1.5 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

10.1 Full-scale bending testing is an effective way to determine flexural properties of structural glued laminated timber (glulam) beams. However, testing of large glulam members is cost prohibitive. Mathematical models, when confirmed by full-scale test results, are useful tools to assign flexural properties for glulam. This practice provides guidelines for sampling and testing full-scale glulam beams to determine their flexural properties and to validate mathematical models intended for use in assigning flexural design values.