Document Center is acquired by Nimonik

1.1 This specification is designed to evaluate adhesives suitable for the bonding of oriented strand board (OSB) to rigid cellular polystyrene insulation core materials for general structure use.

1.2 The requirements of the structural insulated panel (SIP) adhesive are based on the performance of the adhesive as measured by:

1.3 The classification of the adhesive formulation is based on, but not limited to the adhesive’s industry accepted generic names, for example: phenol-resorcinol, emulsion polymer isocyanate, one and two-part urethane. The type of adhesive application and curing terminology are also usually included for classification purposes such as cold-setting phenol resorcinol, heat-cured phenol resorcinol, and hot melt one component urethane.

1.4 Evaluation of adhesive performance at high temperature conditions, such as during a fire exposure, is beyond the scope of this specification.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

4.1 This specification addresses minimum performance criteria for adhesives used to laminate oriented strand board (OSB) structural panel facing material to expanded or extruded polystyrene core materials. Adhesive performance is based on tests that simulate exposure to moisture, temperature, seasonal weathering, and creep. Additionally, the adhesive is to demonstrate resistance to oxidation, mold, chemical reagents, and compatibility to the specific laminating materials.

4.2 The adhesive manufacturers can use this specification for new product development and quality control purposes.

4.3 Structural insulated panel manufacturers rely on an adhesive performance specification that determines its suitability before use.

4.4 Performance of the SIP adhesive when evaluated in accordance with this specification aids in determining the suitability of the adhesive for laminating OSB facings to rigid cellular polystyrene core materials in the manufacture of structural insulated panels.