ASTM-D7654 › Standard Specification for Asphalt Used in Roofing Measured by Dynamic Shear Rheometer
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers two types of asphalt intended for use in built-up roof construction, construction of some modified bitumen systems, construction of bituminous vapor retarder systems, and for adhering insulation boards used in various types of roof systems. The specification is intended for general classification purposes only and does not imply restrictions on the slope at which an asphalt must be used.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
asphalt; built-up roof; dynamic shear rheometer (DSR); roofing; viscosity;; ICS Number Code 91.100.50 (Binders. Sealing materials)
To find similar documents by ASTM Volume:
04.04 (Roofing and Waterproofing)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D7654/D7654M-10(2018)
Revision Level
2010 R18 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 1, 2018
Document Type
Specification
Page Count
3 pages
Committee Number
D08.03