ASTM-E1002 › Standard Practice for Leaks Using Ultrasonics
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 Test Method A, Pressurization- This test method covers procedures for calibration of ultrasonic instruments, location, and estimated measurements of gas leakage to atmosphere by the airborn ultrasonic technique.
1.2 In general practice this should be limited to leaks producing leakage of 4.5 X 10 -7 m /s (10 atm[dot]cm /s at 0°C) or more. Refer to Guide E 432 for additional information.
1.3 Test Method B, Ultrasonic Transmitter- For object under test not capable of being pressurized but capable of having ultrasonic tone placed/injected into the test area to act as an ultrasonic leak trace source.
1.4The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
leak detection-ultrasonic; leak testing; leakage rate; ultrasonic detector; ICS Number Code 19.100 (Non-destructive testing)
To find similar documents by ASTM Volume:
03.03 (Nondestructive Testing)
12.02 (Nuclear (II), Solar, and Geothermal Energy)
To find similar documents by classification:
17.240 (Radiation measurements Including dosimetry Radiation protection, see 13.280)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
10CFR(1-50)Energy
10CFR(0-50)
See: 10CFR(1-50)
ASQC-M1
American National Standard for Calibration Systems
Document Number
ASTM-E1002-11R22
Revision Level
2011 R22 EDITION
Status
Current
Publication Date
July 6, 2022
Document Type
Test Method
Page Count
4 pages
Committee Number
E07.08