Document Center is acquired by Nimonik

Scope

1.1 This is a fire-test-response standard.

1.2 These test methods are designed for the assessment of the resistance of upholstered furniture component assemblies to combustion after exposure to smoldering cigarettes under specified conditions.

1.3 The tests apply to upholstered furniture components-cover fabrics, interior fabrics, welt cords, decking materials, barrier materials, and filling or padding materials including but not limited to: battings of natural or man-made fibers, foamed or cellular filling materials, resilient pads of natural or man-made fibers, and loose particulate filling materials (such as shredded polyurethane or feathers and down).

1.4 The individual test methods and the materials to which they apply are as follows:

1.4.1 Cover Fabric Test -Applies to outer cover fabrics (see Sections 11 and 12).

1.4.2 Interior Fabric Test -Applies to interior fabrics used in intimate contact with outer fabrics (see Sections 13 and 14).

1.4.3 Welt Cord Test -Applies to welt cord (see Sections 15 and 16).

1.4.4 Filling/Padding Component Test -Applies to resilient materials used under the cover fabric in seats or in inside vertical walls (inside arm and inside backs) (see Sections 17 and 18).

1.4.5 Decking Materials Test -Applies to resilient materials used in the deck under loose cushions (see Sections 19 and 20).

1.4.6 Barrier Materials Test -Applies to materials that are intended to serve as a barrier between cover fabric and conventional polyurethane foam (see Sections 21 and 22).

1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard should be used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire hazard assessment or a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard or fire risk of a particular end use.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.

Keywords

cigarette; component; furniture; ignition; reistance; upholstered; ICS Number Code 13.220.40 (Ignitability and burning behaviour of materials and products); 97.140 (Furniture)

To find similar documents by ASTM Volume:

04.07 (Building Seals and Sealants; Fire Standards; Dimension Stone)

To find similar documents by classification:

13.220.40 (Ignitability and burning behaviour of materials and products)

97.140 (Furniture Including upholstery, mattresses, office furniture, school furniture, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.