Document Center is acquired by Nimonik

Scope

1.1 This method covers the radiographic testing of materials for internal discontinuities, and also the use of film and other recording media. Requirements expressed in this method are intended to control the reliability or quality of the radiographic images, and are not intended for controlling the acceptability or quality of materials or products.

1.2 The number of areas or parts to be radiographed and the acceptance standard to be applied shall be specified in the contract, purchase order, product specification, or drawings. The quality level required for radiography shall be at least 2% (2-2T), unless a higher or lower quality is agreed upon by the purchaser and the supplier.

1.3 The values stated in inch-pound units are to be regarded as standard.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (For specific safety precautionary information see Section 15.)

Keywords

Penetrameters; Quality control-radiographic testing; Radiographic testing; controlling quality of radiographic testing, method; ICS Number Code 19.100 (Non-destructive testing)

To find similar documents by ASTM Volume:

03.03 (Nondestructive Testing)

To find similar documents by classification:

19.100 (Non-destructive testing Including testing equipment: industrial apparatus for X-ray and gamma radiography, penetrant flaw detectors, etc. Non-destructive testing of welded joints, see 25.160.40 Industrial radiographic films, see 37.040.25 Non-destructive testing of metals, see 77.040.20)

To find similar documents by Federal Supply Class Code:

FSC Standardization Area NDTI (Nondestructive Testing and Inspection)

This document comes with our free Notification Service, good for the life of the document.

This document is available in Paper format.