ASTM-E154 › Standard Test Methods for Water Vapor Retarders Used in Contact with Earth Under Concrete Slabs, on Walls, or as Ground Cover
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the determination of the properties of flexible membranes to be used as vapor retarders in contact with earth under concrete slabs, against walls, or as ground cover in crawl spaces. The test methods are applicable primarily to plastic films, and other flexible sheets. The materials are not intended to be subjected to sustained hydrostatic pressure. The procedures simulate conditions to which vapor retarders may be subjected prior to and during installation, and in service.
1.2 The test methods included are:
Section Water-Vapor Transmission of Material as Received 7 Water-Vapor Transmission after Wetting and Drying and after Long-Time Soaking 8 Tensile Strength 9 Resistance to Puncture 10 Resistance to Plastic Flow and Elevated Temperature 11 Effect of Low Temperatures on Flexibility 12 Resistance to Deterioration from Organisms and Substances in Contacting Soil 13 Resistance to Deterioration from Petroleum Vehicles for Soil Poisons 14 Resistance to Deterioration from Exposure to Ultraviolet Light 15 Resistance to Flame Spread 16 Report 171.3 The values stated in acceptable metric units shall be considered standard. The values in parentheses are for information only.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Admixtures-soil; Building constructions/materials-crawl spaces; Building constructions/materials-vapor barriers; Concrete slabs; Crawl spaces; Deterioration; Ground covers; Incubation room; Microbiological examination; Microbiological examination-paints/related coatings; Mixed pigments; Potting soil; Resistance-decay; Resistance-puncture; Resistance-vapor barrier materials in buildings; Resistance-water vapor; Soil; Soil burial test; Temperature tests-building materials; Tension (tensile) properties/tests-building materials; Vapor barriers; Water vapor transmission (WVT); Wet tensile strength; water vapor retarders used in contact with earth under concrete slabs on; walls or as ground cover, test,; Resistance-deterioration; from organisms in soil/petroleum vehicles for soil poisons/exposure to; ultraviolet light for water vapor retarders used in contact with earth; under concrete slabs on walls or as ground cover, test; ICS Number Code 91.100.30 (Concrete and concrete products)
To find similar documents by ASTM Volume:
04.11 (Building Constructions (I): E72 - E2110)
To find similar documents by classification:
91.100.30 (Concrete and concrete products Including admixtures)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASME-HST-5Performance Standard for Air Chain Hoists
MIL-C-26482
Connectors, Electrical, (Circular, Miniature, Quick Disconnect, Environment Resisting)
CGA-C7
Guide to Classification and Labeling of Compressed Gases
Document Number
ASTM-E0154_E0154M-08AR13E01
Revision Level
2008A R19 EDITION
Status
Current
Modification Type
Revision
Publication Date
July 4, 2019
Document Type
Test Method
Page Count
7 pages
Committee Number
E06.21