Document Center is acquired by Nimonik

Scope

1.1 The purpose of this practice is to present concepts necessary to the understanding of the terms “precision” and “bias” as used in quantitative test methods. This practice also describes methods of expressing precision and bias and, in a final section, gives examples of how statements on precision and bias may be written for ASTM test methods.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

Significance and Use

Part A of the “Blue Book,” Form and Style for ASTM Standards, requires that all test methods include statements of precision and bias. This practice discusses these two concepts and provides guidance for their use in statements about test methods.

Precision—A statement of precision allows potential users of a test method to assess in general terms the test method's usefulness with respect to variability in proposed applications. A statement of precision is not intended to exhibit values that can be exactly duplicated in every user's laboratory. Instead, the statement provides guidelines as to the magnitude of variability that can be expected between test results when the method is used in one, or in two or more, reasonably competent laboratories. For a discussion of precision, see Section 15.

Bias—A statement of bias furnishes guidelines on the relationship between a set of typical test results produced by the test method under specific test conditions and a related set of accepted reference values (see Section 16).

An alternative term for bias is trueness, which has a positive connotation, in that greater bias is associated with less favorable trueness. Trueness is the systematic component of accuracy.

Accuracy—The term “accuracy,” used in earlier editions of Practice E 177, embraces both precision and bias (see Section 17 and Note 3).

A Table of Contents is shown below, listing the concepts in this standard.

Keywords

accepted reference value; accuracy; bias; interlaboratory study; precision; precision conditions; repeatability; reproducibility; standard deviation; Accuracy assessment; ASTM voluntary consensus standards; Bias; Measurement processes/systems; Precision--construction materials test methods; Statistical methods; ICS Number Code 19.020 (Test conditions and procedures in general)

To find similar documents by ASTM Volume:

14.02 (General Test Methods; Forensic Psychophysiology; Forensic Sciences; Terminology; Conformity Assessment; Statistical Methods; Nanotechnology; Forensic Engineering; Manufacture of Pharmaceutical Products)

To find similar documents by classification:

19.020 (Test conditions and procedures in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.