ASTM-E1935 › Standard Test Method for Calibrating and Measuring CT Density
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers instruction for determining the density calibration of X and y-ray computed tomography (CT) systems and for using this information to measure material densities from CT images. The calibration is based on an examination of the CT images of a disk of material with embedded specimens of know composition and density. The measured mean CT values of the known standards are determined from an analysis of the image, and their linear attenuation coefficients are determined by multiplying their measured physical density by their published mass attenuation coefficient. The density calibration is performed by applying a linear regression to the data. Once calibrated, the linear attenuation coefficient of an unknown feature in an image can be measured from a determination of its mean CT value. Its density can then be extracted from a knowledge of its mass attenuation coefficient, or one representative of the feature.
1.2 CT provides an excellent method of nondestructively measuring density variations, which would be very difficult to quantify otherwise. Density is inherently a volumetric property of matter. As the measurement volume shrinks, local material inhomogeneities become more important; and measured values will begin to vary about the bulk density value of the material.
1.3 All values are stated in SI units.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
computed tomography; contrast sensitivity; CT density resolution; density calibration; linear attenuation coefficient; mass attenuation coefficient
To find similar documents by ASTM Volume:
03.03 (Nondestructive Testing)
To find similar documents by classification:
35.240.80 (IT applications in health care technology Including computer tomography)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E1935-97R19
Revision Level
1997 R19 EDITION
Status
Current
Modification Type
New
Publication Date
Dec. 1, 2019
Document Type
Test Method
Page Count
5 pages
Committee Number
E07.01