Document Center is acquired by Nimonik

Scope

1.1 This test method covers a general procedure for the measurement of the fast-neutron fluence rate produced by neutron generators utilizing the H(d,n) He reaction. Neutrons so produced are usually referred to as 14-MeV neutrons, but range in energy depending on a number of factors.

1.2 This test method uses the following threshold activation reactions: in aluminum, 27 Al(n,[alpha]) Na and 27 Al(n,p) Mg; in nickel, Ni(n,p) Co and Ni(n,2n) Ni; and in copper, Cu(n,2n) Cu and Cu(n,2n) Cu. The neutron fluence rate is determined from induced foil activities (as measured by gamma spectrometry) and reaction cross-section data.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

14-MeV; DT; neutron activation; neutron generator; neutron metrology; ICS Number Code 17.240 (Radiation measurements); 27.120.30 (Fissile materials and nuclear fuel technology)

To find similar documents by ASTM Volume:

12.02 (Nuclear (II), Solar, and Geothermal Energy)

To find similar documents by classification:

17.240 (Radiation measurements Including dosimetry Radiation protection, see 13.280)

27.120.30 (Fissile materials and nuclear fuel technology Including raw materials Radioactive wastes, see 13.030.30)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.