ASTM-E754 › Standard Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method provides procedures for determining the ability of individual masonry ties and anchors to resist extraction from a masonry mortar joint.
1.2 Two laboratory testing procedures are provided for use with test specimens which consist of a masonry tie or anchor embedded in mortar between twin stack-bonded masonry units.
1.2.1 Procedure A -For use with small (brick-size) masonry units.
1.2.2 Procedure B -For use with large (block-size) masonry units.
1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
anchors; masonry; mortar joints; ties; ICS Number Code 91.060.01 (Elements of buildings in general)
To find similar documents by ASTM Volume:
04.11 (Building Constructions (I): E72 - E2110)
To find similar documents by classification:
91.060.01 (Elements of buildings in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E0754-80R22
Revision Level
1980 R22 EDITION
Status
Current
Modification Type
Editorially changed
Publication Date
Oct. 6, 2022
Document Type
Test Method
Page Count
8 pages
Committee Number
E06.13