Document Center is acquired by Nimonik

Scope

1.1 This practice covers the preparation of RDF laboratory samples for analysis, the laboratory samples having been previously obtained from representative RDF samples.

1.2 The determination of the air-dry loss of the RDF is part of this preparation procedure and must be performed prior to the particle size reduction.

1.3 The practice given may also be used for other RDF types but additional sample preparation steps may be necessary prior to the application of this method.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 7.

Keywords

Particle analysis-refuse-derived fuel/RDF; Resource recovery-solid waste refuse-derived fuel/RDF; Sieve analysis-refuse-derived fuel/RDF; preparing samples for analysis,; Specimen preparation (for testing)-water testing; refuse-derived fuel/RDF laboratory samples, method; ICS Number Code 13.030.50 (Recycling); 75.160.10 (Solid fuels)

To find similar documents by ASTM Volume:

11.04 (Waste Management)

To find similar documents by classification:

13.030.50 (Recycling Including relevant equipment Motor vehicle recycling, see 43.020)

75.160.10 (Solid fuels Including coal products, coke, peat, wood, derivatives of coal pyrolysis, etc. Coals, see 73.040)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.