ASTM-F1662 › Standard Test Method for Verifying the Specified Dielectric Withstand Voltage and Determining the Dielectric Breakdown Voltage of a Membrane Switch or Printed Electronic Device (Withdrawn 2023)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the verification of a specified dielectric withstand voltage or dielectric breakdown voltage of a membrane switch or printed electronic device.
Significance and Use
4.1 Dielectric withstand voltage testing is useful for design verification, quality control of materials, and workmanship.
4.2 This test method is used to verify that the membrane switch or printed electronic device can operate safely at its rated voltage, and withstand momentary overpotentials due to switching, surges and other similar electrical phenomena.
4.3 Specific areas of testing are, but not limited to:
4.3.1 Conductor/dielectric/conductor crossing point,
4.3.2 Close proximity of conductors, and
4.3.3 Any other conductive surface such as shielding or metal backing panel.
4.4 Dielectric withstand voltage testing may be destructive and units that have been tested should be considered unreliable for future use.
4.5 Testing using ac voltage may be useful for switches intended for control circuits powered by ac voltages.
Keywords
dielectric withstand voltage; dielectric breakdown voltage; membrane switch;
To find similar documents by ASTM Volume:
10.04 (Electronics; Declarable Substances in Materials; 3D Imaging Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-F2073Standard Test Method for Non-Destructive Short Circuit Testing of a Membrane Switch (Withdrawn 2023)
ISO/IEC-15693-1
Cards and security devices for personal identification - Contactless vicinity objects - Part 1: Physical characteristics
ASTM-F1663
Standard Test Method for Determining the Capacitance of a Membrane Switch or Printed Electronic Device (Withdrawn 2024)
Document Number
ASTM-F1662-16
Revision Level
2016 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
May 15, 2016
Document Type
Test Method
Page Count
2 pages
Committee Number
F01.18