ASTM-F3337 Historical Revision Information
Standard Guide for Taking Property and Behavior Measurements on Weathered Fractions of Oil

ASTM-F3337 - 2019 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Guide for Taking Property and Behavior Measurements on Weathered Fractions of Oil
ORDER

Scope

1.1 This guide summarizes methods to fractionate oil by evaporative weathering and then measure the properties and behavior of the weathered oil. The results of this guide can provide oil behavior data for input into oil spill models and response method selection.

1.2 This guide covers general procedures for oil weathering and behavior and does not cover all possible procedures which may be applicable to this topic.

1.3 The results obtained using this guide are intended to provide baseline data for the behavior of oil and petroleum products when spilled and input to oil spill models.

1.4 The results obtained using this guide can be used directly to predict certain facets of oil spill behavior or as input to oil spill models.

1.5 The accuracy of the guide depends very much on the representative nature of the oil sample used. Certain oils can have different properties depending on their chemical contents at the moment a sample is taken

1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Significance and Use

5.1 A standard procedure is necessary to establish property changes for spilled oils or petroleum products at different oil weathering stages.

5.2 This procedure employs standardized equipment, and test procedures.

5.3 This procedure should be performed at the stages of weathering corresponding to the spill conditions of interest.

Keywords

oil behavior with weathering; oil properties with weathering; oil weathering;

To find similar documents by classification:

13.020.40 (Pollution, pollution control and conservation Including ecotoxicology)

75.080 (Petroleum products in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-F3337-19

Revision Level

2019 EDITION

Status

Superseded

Modification Type

New

Publication Date

March 21, 2019

Document Type

Guide

Page Count

4 pages

Committee Number

F20.16