Document Center is acquired by Nimonik

Scope

1.1 This specification covers requirements and test methods for materials, marking dimensions, workmanship, elongation, brittleness, pipe stiffness, and perforations for corrugated polyethylene (PE) tubing and fittings in nominal sizes of 3 to 6 in., inclusive.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.4 The following precautionary caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Agricultural drainage; Corrugated polyethylene (PE) tube; Land drainage piping systems; Pipe fittings; Polyethylene (PE) fittings; ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)

To find similar documents by ASTM Volume:

08.04 (Plastic Piping Systems)

To find similar documents by classification:

23.040.20 (Plastics pipes)

23.040.45 (Plastics fittings)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.