ASTM-F467 › Historical Revision Information
Standard Specification for Nonferrous Nuts for General Use
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the chemical, mechanical, dimensional, and workmanship and finish requirements, and the corresponding test methods for commercial wrought nonferrous nuts in a variety of alloys in common use that are intended for general service applications. When tested, the nuts shall meet required values for hardness, proof stress, and tensile stress areas.
Scope
1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general service applications.
1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this specification are covered by Specification F468.
1.3 This specification is the inch-pound companion to Specification F467M; therefore, no SI equivalents are presented in the specification.
Significance and Use
For purposes of determining compliance with the specified limits for requirements of the properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29.
Keywords
general use; nonferrous; nuts; Fasteners (metal)--specifications; Naval brass; Nickel-copper alloy--specifications; Nickel-copper-aluminum alloys; Nickel-molybdenum alloys--specifications; UNS R50550 (Ti, unalloyed); Nickel-molybdenum-chromium alloys--specifications; Nonferrous bolting materials; Palladium (titanium plus palladium)--specifications; Titanium plus palladium--specifications; Titanium (Ti)/alloys--specifications; UNS N04400 (Ni-Cu alloy, Monel 400); UNS N04405 (Ni-Cu alloy solution strengthened (Monel R405)); UNS N05500 (Ni-Cu alloy, Monel K500); UNS N10001 (Ni-Mo alloy, Hastelloy B); UNS N10002 (Ni-Mo alloy, Hastelloy C); UNS N10665 (Ni-Mo alloy, Hastelloy B-2); UNS R50250 (Ti, unalloyed); UNS R50400 (Ti, unalloyed); UNS R50700 (Ti, unalloyed); Yellow brass; ICS Number Code 21.060.20 (Nuts)
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F467-08e1
Revision Level
2008(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Oct. 1, 2009
Document Type
Specification
Page Count
10 pages
Committee Number
F16.04