ASTM-F467 › Historical Revision Information
Standard Specification for Nonferrous Nuts for General Use
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the requirements for commercial wrought nonferrous nuts in nominal thread diameters M6 to M36 inclusive in a number of alloys in common use and intended for general service applications. Materials shall be tested and shall conform to the chemical composition, hardness, proof stress, proof load, and tensile stress requirements.
Scope
1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general service applications.
1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this specification are covered by Specification F468.
1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
Significance and Use
11.1 For purposes of determining compliance with the specified limits for requirements of the properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29.
Keywords
general use; nonferrous; nuts; ICS Number Code 21.060.20 (Nuts)
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F467-13e2
Revision Level
2013(E2) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
June 1, 2014
Document Type
Specification
Page Count
10 pages
Committee Number
F16.04