Document Center is acquired by Nimonik

Scope

1.1 This test method covers the laboratory procedure for determining the abrasion resistance of resilient flooring using an abrader with a grit feeder.

1.2 The equipment used in this test method is a modification of the Taber abraser. The regular ceramic wheels are replaced by leather clad brass rollers. A grit-feeding device feeds 240-mesh aluminum oxide grit onto the specimen before it passes under the leather clad rollers. Using the exhaust system incorporated in the apparatus, the used grit and abraded material are continuously removed after passing under both rollers.

1.3 This test method employs a rotary, rubbing action caused by the dual abrading wheels. One wheel rubs the specimen from the center outward and the other from the outside toward the center. The wheels traverse a complete circle and have an abrasive action on the rotating specimen at all angles. It is felt that this action approaches the twisting action between shoe and floor that occurs when a person turns. The use of loose grit serves the function of an abradant and also aids in the rolling action felt to be characteristic of normal walking.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

When subjected to normal in-use traffic conditions, a flooring material is exposed to abrasion caused by the destructive action of fine hard particles. This situation occurs whenever a particle-polluted intermediate layer exists between traffic bodies (that is, shoes and a flooring surface). Under continuing exposure to an “abrasive action,” a flooring material may suffer a thickness loss sufficient to reduce its service life.

Abrasion resistance measurements of resilient floor coverings can be complicated since the resistance to abrasion is affected by many factors. One of these is the physical properties of the material in the floor covering surface, particularly its hardness and resilience. The type and degree of added substances, such as fillers and pigments, can also affect abrasion resistance. It can also be affected by conditions of the test (for example, the type and characteristics of the abradant and how it acts on the area of the specimen being abraded, including the development and dissipation of heat during the test cycle). The surface characteristics of the specimen, such as type, depth, and amount of embossing, can likewise affect the abrasion resistance of resilient floorings.

This test method is designed to simulate one kind of abrasive action and abradant that a flooring may encounter in the field. However, results should not be used as an absolute index of ultimate life because, as noted, there are too many factors and interactions to consider. Also involved are the many different types of service locations. Therefore, the data from this test method are of value chiefly in the development of materials and should not be used without qualifications as a basis for commercial comparisons.

Keywords

abrasion resistance; aluminum oxide; grit feed; resilient flooring; Taber abraser; ICS Number Code 97.150 (Non-textile floor coverings)

To find similar documents by ASTM Volume:

15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)

To find similar documents by classification:

97.150 (Non-textile floor coverings Textile floor coverings, see 59.080.60)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.