ASTM-F594 › Historical Revision Information
Standard Specification for Stainless Steel Nuts
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the requirements for stainless steel nuts in specified size, inclusive, in nominal diameter in a number of alloys in common use and intended for service applications requiring general corrosion resistance. Seven groups of stainless steel alloys are covered, including ten austenitic, two ferritic, four martensitic, and one precipitation hardening: Group 1; Group 2; Group 3; Group 4; Group 5; Group 6; and Group 7. The finished fasteners shall meet the applicable mechanical properties. Chemical tests; mechanical tests; and corrosion resistance shall be performed to conform with the specified requirements.
Scope
1.1 This specification covers the requirements for stainless steel nuts 0.25 to 1.50 in., inclusive, in nominal diameter in a number of alloys in common use and intended for service applications requiring general corrosion resistance.
Significance and Use
For the purposes of determining compliance with the specified limits for properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29.
Keywords
Corrosive service applications; Nuts--specifications; Stainless steel bolting materials--specifications; ICS Number Code 21.060.20 (Nuts)
To find similar documents by ASTM Volume:
01.08 (Fasteners; Rolling Element Bearings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F594-09e1
Revision Level
2009(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Jan. 1, 2011
Document Type
Specification
Page Count
8 pages
Committee Number
F16.04