ASTM-G38 › Historical Revision Information
Standard Practice for Making and Using C-Ring Stress-Corrosion Test Specimens
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes the essential features of the design and machining, and procedures for stressing, exposing, and inspecting C-ring type of stress-corrosion test speci- mens. An analysis is given of the state and distribution of stress in the C-ring.
1.2 Specific considerations relating to the sampling process and to the selection of appropriate test environments are outside the scope of this practice.
1.3 The values stated in SI units are to be regarded as standard. The inch-pound units are provided for information.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
constant load; constant strain; C-rings; notches; quantitative stress; stress-corrosion crackling; stress-corrosion test specimen; ICS Number Code 77.060 (Corrosion of metals)
To find similar documents by ASTM Volume:
03.02 (Corrosion of Metals; Wear and Erosion)
To find similar documents by classification:
77.060 (Corrosion of metals Surface treatment and coating, see 25.220)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-G38-73(1990)e1
Revision Level
1973 R90(E1) EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
Sept. 27, 1973
Document Type
Practice
Page Count
6 pages
Committee Number
G01.06