Document Center is acquired by Nimonik

Scope

1.1 This test method covers a uniform procedure for characterizing the resistance to stress-corrosion cracking (SCC) of high-strength aluminum alloy wrought products for the guidance of those who perform stress-corrosion tests, for those who prepare stress-corrosion specifications, and for materials engineers.

1.2 This test method covers method of sampling, type of specimen, specimen preparation, test environment, and method of exposure for determining the susceptibility to SCC of 2XXX (with 1.8 to 7.0 % copper) and 7XXX (with 0.4 to 2.8 % copper) aluminum alloy products, particularly when stressed in the short-transverse direction relative to the grain structure.

1.3 The values stated in SI units are to be regarded as standard. The inch-pound units in parentheses are provided for information.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

The 3.5 % NaCl solution alternate immersion test provides a test environment for detecting materials that would be likely to be susceptible to SCC in natural outdoor environments, especially environments with marine influences.^{3 ,4 ,5} For determining actual serviceability of a material, other stress-corrosion tests should be performed in the intended service environment under conditions relating to the end use, including protective measures.

Although this test method is intended for certain alloy types and for testing products primarily in the short-transverse stressing direction, this method is useful for some other types of alloys and stressing directions.

Keywords

accelarated testing; aluminum alloys; corrosion; heat-treatable aluminum alloys; stress-corrosion cracking; tension; ICS Number Code 77.120.10 (Aluminium and aluminium alloys)

To find similar documents by ASTM Volume:

03.02 (Corrosion of Metals; Wear and Erosion)

To find similar documents by classification:

77.040.30 (Chemical analysis of metals Chemical analysis in general, see 71.040.40 Chemical analysis of ferrous metals, see 77.080 Chemical analysis of ferroalloys, see 77.100 Chemical analysis of non-ferrous metals, see 77.120 Chemical analysis of sintered metals and hard metals, see 77.160)

77.120.10 (Aluminium and aluminium alloys)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.