ASTM-G99 › Historical Revision Information
Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes a laboratory procedure for determining the wear of materials during sliding using a pin-on-disk apparatus. Materials are tested in pairs under nominally non-abrasive conditions. The principal areas of experimental attention in using this type of apparatus to measure wear are described. The coefficient of friction may also be determined.
1.2 The values stated in SI units are to be regarded as standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
ceramic wear; friction; metal wear; non-abrasive; pin-on-disk; wear; ICS Number Code 17.040.20 (Properties of surfaces)
To find similar documents by ASTM Volume:
03.02 (Corrosion of Metals; Wear and Erosion)
To find similar documents by classification:
17.040.20 (Properties of surfaces)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-G99-90
Revision Level
1990 EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
April 27, 1990
Document Type
Test Method
Page Count
5 pages
Committee Number
G02.40