IEC-60286-3 › Historical Revision Information
Packaging of components for automatic handling - Part 3: Packaging of surface mount components on continuous tapes
Document Center Inc. is an authorized dealer of IEC standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
IEC 60286-3:2019 is applicable to the tape packaging of electronic components without leads or with lead stumps, intended to be connected to electronic circuits. It includes only those dimensions that are essential for the taping of components intended for the above-mentioned purposes. This document also includes requirements related to the packaging of singulated die products including bare die and bumped die (flip chips). This edition includes the following significant technical changes with respect to the previous edition:
- addition of a table of the classification to symbols concerning tape, reel and common symbols;
- additions of a figure of example of polarity and orientation and a figure of example of dot seal;
- revision of requirements for camber;
- addition of a definition of design value with regard to tilt.
To find similar documents by classification:
31.020 (Electronic components in general Magnetic components, see 29.100.10)
31.240 (Mechanical structures for electronic equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
IEC 60286-3 Ed. 6.0 b:2019
Revision Level
EDITION 6.0
Status
Superseded
Publication Date
Jan. 1, 2019
Committee Number
40