ISO-10683 › Historical Revision Information
Fasteners - Non-electrolytically applied zinc flake coatings
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 10683:2014 specifies requirements for non-electrolytically applied zinc flake coatings for steel fasteners. It applies to coatings:
- with or without hexavalent chromium;
- with or without top coat;
- with or without lubricant (integral lubricant and/or subsequently added lubricant).
It applies to bolts, screws, studs and nuts with ISO metric thread, to fasteners with non-ISO metric thread, and to non-threaded fasteners such as washers, pins, clips, etc.
ISO 10683:2014 does not specify requirements for such fastener properties as weldability or paintability. It does not apply to mechanically applied zinc coatings.
To find similar documents by classification:
21.060.01 (Fasteners in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 10683:2014
Revision Level
2ND EDITION
Status
Superseded
Publication Date
May 15, 2014
Committee Number
ISO/TC 2/SC 14