ISO-10684 › Fasteners - Hot dip galvanized coatings

ISO-10684 - 1ST EDITION - CURRENT


Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Included in this current edition are the following subparts:

 1ST EDITION - July 15, 2004
 1ST EDITION CORRIGENDUM 1 - July 15, 2008

ISO 10684:2004 specifies material, process, dimensional and some performance requirements for hot dip spun galvanized coatings applied to coarse threaded steel fasteners from M8 up to and including M64 and for property classes up to and including 10.9 for bolts, screws and studs and 12 for nuts. It is not recommended to hot dip galvanize threaded fasteners in diameters smaller than M8 and/or with pitches below 1,25 mm.

ISO 10684:2004 primarily concerns the spun hot dip galvanizing of threaded steel fasteners, but it may also be applied to other threaded steel parts. The specifications given in this document may also be applied to non-threaded steel parts such as washers.

ORDER

Price:

$161.02        


Want this as a site license?

To find similar documents by classification:

21.060.01 (Fasteners in general)

25.220.40 (Metallic coatings Including electrolytic depositions, cathodic coatings, autocatalytic coatings, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 10684:2004

Revision Level

1ST EDITION

Status

Current

Publication Date

July 15, 2004

Committee Number

ISO/TC 2/SC 1