ISO-10985 Caps made of aluminium-plastics combinations for infusion bottles and injection vials - Requirements and test methods

ISO-10985 - 3RD EDITION - SUPERSEDED -- See the following: ISO-8872
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 10985:2009 specifies general requirements and test methods for caps made of aluminium-plastics combinations in accordance with ISO 8536-7 or ISO 8362-6 intended for use respectively on infusion bottles as specified in ISO 8536-1 and/or injection bottles as specified in ISO 8362-1 and ISO 8362-4.

The purpose of ISO 10985:2009 is to specify caps that provide:

  • guarantee of originality of the closure up to the point of administration;
  • compression of the sealing element (rubber closure) on to the sealing surfaces of the infusion and/or injection bottles;
  • protection of the sealing element against soiling and mechanical damage;
  • simple and injury-free opening of the closure in order to expose the penetration area of the rubber closure and/or to permit total removal of the cap.

To find similar documents by classification:

11.040.20 (Transfusion, infusion and injection equipment Including blood packs Syringes, needles and catheters, see 11.040.25)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

ISO/IEC-16022
Information technology - Automatic identification and data capture techniques - Data Matrix bar code symbology specification

ISO/IEC-13211-1
Information technology - Programming languages - Prolog - Part 1: General core

IEC-60529
Degrees of protection provided by enclosures (IP Code)

Document Number

ISO 10985:2009

Revision Level

3RD EDITION

Status

Superseded

Publication Date

Feb. 15, 2009

Committee Number

ISO/TC 76