ISO-14270 › Resistance welding - Destructive testing of welds - Specimen dimensions and procedure for mechanized peel testing resistance spot, seam and embossed projection welds
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 14270:2016 specifies specimen dimensions and a testing procedure for mechanized peel testing of single spot, seam and embossed projection welds, in overlapping sheets, in any metallic material of thickness 0,5 mm to 3 mm, where the welds have a maximum diameter of 7√t (where t is the sheet thickness in mm).
For welds of diameter between 5√t and 7√t, the peel strength values obtained may be lower than expected when using the recommended test specimen dimensions because the test specimen width is designed for welds of diameter of 5√t or less.
The object of mechanized peel testing is to determine the peel strength that the test specimen can sustain.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ISO-273Fasteners - Clearance holes for bolts and screws
AWS-D1.1
Structural Welding Code - Steel (Now AWS-D1.1/D1.1M)
AMS-4050
Aluminum Alloy, Plate, 6.2Zn - 2.3Cu - 2.2Mg - 0.12Zr (7050-T7451), Solution Heat Treated, Stress Relieved, and Overaged
Document Number
ISO 14270:2016
Revision Level
2ND EDITION
Status
Current
Publication Date
Jan. 1, 2016
Committee Number
IIW