ISO-28078-1 › Plastics - Poly(phenylene sulfide) (PPS) moulding and extrusion materials - Part 1: Designation system and basis for specifications
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 28078-1:2009 establishes a system of designation for PPS thermoplastic materials, which may be used as the basis for specifications.
The types of PPS plastic are differentiated from each other by a classification system based on appropriate levels of the designatory properties
- melt mass-flow rate or melt viscosity
- density
- tensile modulus
and on information about the intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials.
ISO 28078-1 is applicable to all PPS materials.
It applies to materials ready for normal use in the form of powder, granules or pellets and to materials unmodified or modified by colorants, additives, fillers, etc.
To find similar documents by classification:
83.080.20 (Thermoplastic materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 28078-1:2009
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Oct. 15, 2009
Committee Number
ISO/TC 61/SC 9