ISO-3075 › Short link chain for lifting purposes - Grade S (6) non calibrated, for chain slings etc.
ISO-3075
-
1ST EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Specifies the requirements for lifting chains, grade S (6), non-calibrated, for use on cranes, in chain slings and for general lifting purposes. These are electrically welded round steel short link chains, fully heat treated and tested complying with ISO 1834. The range of sizes covered is from 5 to 45 mm. The annex gives a range of temporary additional sizes 6 to 30 mm.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 3075:1980
Revision Level
1ST EDITION
Status
Current
Publication Date
Aug. 1, 1980
Committee Number
ISO TC 111/SC 1