SS-248262 › Rubber and plastics hoses and hose assemblies for use with LPG and natural gas in the vapour phase up to 2,0 MPa - Requirements for rubber and plastics tubing and hose
SS-248262
-
2009 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This standard specifies: the characteristics and performance requirements for tubing, hoses and assemblies made of either rub-ber or plastics in sizes up to a nominal inside diameter, DI, of 12,5 mm for use with commercial propane and butane and mixtures thereof, in the vapour phase, for the connection of appliances in environments with a temperature range from 30 °C to + 60 °C and working pressures from 0,02 MPa to 2,0 MPa; NOTE Connection of appliances could be for instance, from pressurized gas container to a regulator, or a regulator to an appliance or to a metal tubing the characteristics and performance requirements of the coupling tails and hose assemblies used with, or manufactured from rubber and plastic hoses and tubing in a temperature range from 30°C to + 60°C. This standard specify one tubing and one hose. NOTE Rubber and plastics tubing, hoses and assemblies conforming to this standard can be used where contact with appliances having a maximum surface temperature of 90 °C may occur. This standard does not apply to hoses for welding purposes
To find similar documents by classification:
23.040.70 (Hoses and hose assemblies)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS 248262:2009
Revision Level
2009 EDITION
Status
Current
Publication Date
July 13, 2009
Language(s)
English
Page Count
32