SS-EN-10111 › Continuously hot rolled low carbon steel sheet and strip for cold forming - Technical delivery conditions
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies the grades of continuously hot rolled low carbon steel sheet and strip (in coils) for cold forming. Depending on its actual width, strip is classified as: -- hot rolled wide strip if its width is greater than or equal to 600 mm; -- hot rolled slit wide strip if its width is less than 600 mm. For each grade, it specifies the chemical composition and the mechanical properties. This European Standard is applicable to products of thickness not less than 1,0 mm and not exceeding 11 mm. This European Standard is not applicable to products covered by other standards, such as: -- hot rolled products of non-alloy structural steels for general use (see EN 10025 all parts); -- steel sheet for pressure purposes (see EN 10028 all parts); -- steel sheet for welded gas cylinders (see EN 10120); -- quenched and tempered steels (see EN 10083-1 and EN 10083-2).
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 10111:2008
Revision Level
2008 EDITION
Status
Current
Publication Date
April 14, 2008
Language(s)
English
Page Count
24
International Equivalent
EN 10111:2008(IDT)