SS-EN-818-7 › Short link chain for lifting purposes - Safety - Part 7: Fine tolerance hoist chain, Grade T (Types T, DAT and DT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This European Standard specifies the requirements related to safety for hoist chain, Grade T (type T quenched and tempered and types DAT and DT case hardened), for use in serial chain hoists manual and power driven. Type DAT and type DT hoist chains possess surface hardnesses greater than core hardness and are used for power driven chain hoists to offer greater resistance to wear. Type DT hoist chain differs from DAT hoist chain in having higher surface hardness and/or greater case depth to optimise wear resistance. The standard is applicable to electrically welded round steel short link hoist chains conforming to EN 818-1. The range of nominal size of hoist chains covered by this European Standard is from 4 mm to 22 mm. The hazards covered by this European Standard are identified in clause 4.
To find similar documents by classification:
Machinery. Revised Machinery Directive
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN 818-7+A1:2008
Revision Level
2002/A1 EDITION
Status
Current
Publication Date
April 14, 2008
Language(s)
English
Page Count
44
International Equivalent
EN 818-7:2002+A1:2008(IDT)