SS-ISO-10460 › Gas cylinders - Welded carbon-steel gas cylinders - Periodic inspection and testing (ISO 10460:2005, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard deals with welded, carbon-steel, transportable gas cylinders intended for compressed and liquefied gases under pressure, of water capacity from 0,5 l to 150 l; it also applies, as far as practical, to cylinders of less than 0,5 l water capacity and greater than 150 l up to 450 l. This International Standard specifies the requirements for periodic inspection and testing to verify the integrity of such gas cylinders for further service. This International Standard does not apply to the periodic inspection and testing of acetylene cylinders or composite (fully wrapped or hoop-wrapped) cylinders. This International Standard is primarily for industrial gases other than liquefied petroleum gas (LPG), but may also be applied for LPG. For specific LPG applications, see ISO 10464.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 10460:2005
Revision Level
2005 EDITION
Status
Superseded
Publication Date
May 31, 2005
Language(s)
English
Page Count
25
International Equivalent
ISO 10460:2005(IDT)