SS-ISO-12151-1 › Connections for hydraulic fluid power and general use - Hose fittings - Part 1: Hose fittings with ISO 8434-3 O-ring face seal ends (ISO 12151-1:2010, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Included in this current edition are the following subparts:
2010 EDITION - Sept. 20, 2010
FOR 2010 EDITION AMENDMENT 1 SEE - Nov. 28, 2021
FOR 2010 EDITION AMENDMENT 1 SEE - Nov. 28, 2021
This part of ISO 12151 specifies the general and dimensional requirements for the design and performance of hose fittings with O-ring face seal ends in accordance with ISO 8434-3, made of carbon steel, for nominal hose inside diameters of 6,3 mm to 38 mm, inclusive, in accordance with ISO 4397.NOTE 1 Materials other than carbon steel can be supplied as agreed between the manufacturer and user. NOTE 2 For hose fittings used in hydraulic and pneumatic braking systems on road vehicles (as defined in the scope of ISO/TC 22, Road vehicles), see ISO 4038, ISO 4039-1 and ISO 4039-2.
To find similar documents by classification:
23.040.70 (Hoses and hose assemblies)
23.100.40 (Piping and couplings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 12151-1:2010
Revision Level
2010 EDITION
Status
Current
Publication Date
Sept. 20, 2010
Language(s)
English
Page Count
28
International Equivalent
ISO 12151-1:2010(IDT)