SS-ISO-13318-3 › Determination of particle size distribution by centrifugal liquid sedimentation methods - Part 3: Centrifugal X-ray method (ISO 13318-3:2004, IDT)
SS-ISO-13318-3
-
2004 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 13318 describes a method for determining the particle size distribution of homogeneous particulate material using centrifugal sedimentation in a liquid. Solids concentrations are determined by the attenuation of an X-ray beam. The resulting signal enables conversion to a particle size distribution. The method of determining the particle size distribution described in this standard is applicable to powders which can be dispersed in liquids or powders which are present in slurry form. The typical particle size range for analysis is from 0,1 µm to 5 µm. The method is applicable to powders in which all particles have the same effective density, chemical composition and comparable shapes. Materials possessing elements with an atomic number greater than about 12 can be expected to produce adequate X-ray opacity. Particles should not undergo chemical or physical change in the suspension liquid. It is necessary that the particles have a higher density than that of the liquid.
To find similar documents by classification:
19.120 (Particle size analysis. Sieving Including test sieves and porosimetry)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 13318-3:2004
Revision Level
2004 EDITION
Status
Current
Publication Date
Nov. 12, 2004
Language(s)
English
Page Count
13
International Equivalent
ISO 13318-3:2004(IDT)