SS-ISO-4927 › Road vehicles - Elastomeric boots for cylinders, drum type, hydraulic brake wheel cylinders using a non-petroleum base hydraulic brake fluid (Service temperature 120 degrees C max.) (ISO 4927:2005, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies performance tests for moulded rubber boots used at end closures on drum type wheel brake cylinders. These boots prevent the entrance of dirt and moisture which could cause corrosion and otherwise impair wheel brake operation. This International Standard is applicable to boots of both plain and reinforcement insert types, for fitting in wheel cylinders using a fluid in accordance with ISO 4925. It does not include requirements relating to chemical composition, tensile strength or elongation at brake of the rubber compound. It does not cover the strength of adhesion of rubber to the reinforcement in the insert type. The rubber material used in these boots shall be suitable for operation in a temperature range of - 40 °C to + 120 °C.
To find similar documents by classification:
83.140.50 (Seals Seals for general use, see 21.140 and 23.040.80)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 4927:2005
Revision Level
2005 EDITION
Status
Current
Publication Date
Aug. 12, 2005
Language(s)
English
Page Count
9