SS-ISO-7267-2 › Rubber-covered rollers - Determination of apparent hardness - Part 2: Shore-type durometer method (ISO 7267-2:2008, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 7267 specifies a method for the determination of the apparent hardness of vulcanized- or thermoplastic-rubber roller covers, expressed in Shore hardness, for measurement where only medium precision is required. The method and apparatus used are essentially those described in ISO 7619-1, the measurements in this case being made on the curved surface of the conditioned rubber-covered roller rather than on a flat test piece. Shore type A and type D instruments are specified, the latter being used for measurements on rollers of high hardness. NOTE With some rollers, there may be significant variation in the thickness of the rubber over the surface of the roller, which could affect the measured apparent hardness.
To find similar documents by classification:
83.140.99 (Other rubber and plastics products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 7267-2:2008
Revision Level
2008 EDITION
Status
Superseded
Publication Date
Sept. 15, 2008
Language(s)
English
Page Count
16
International Equivalent
ISO 7267-2:2008(IDT)