SS-ISO-7440-1 › Road vehicles - Fuel injection equipment testing - Part 1: Calibrating nozzle and holder assemblies (ISO 7440-1:1991, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 7440 specifies two types of calibrat- ing nozzle and holder assemblies intended for the testing and setting of diese1 fuel injection Pumps on test benches. lt applies to a) a calibrating nozzle and holder assembly with a Single hole orifice plate; b) a calibrating nozzle and holder assembly with a delay pintle type nozzle. The approximate range of the calibrating nozzle and holder assembly is up to - 300. mm3/stroke with the Single hole orifice plate - 150 mm3/stroke with the delay pintle type nozzle.
To find similar documents by classification:
43.060.01 (Internal combustion engines for road vehicles in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 7440-1:2007
Revision Level
2007 EDITION
Status
Current
Publication Date
Dec. 5, 2007
Language(s)
English
Page Count
24
International Equivalent
ISO 7440-1:1991(IDT)