SS-ISO-8779-AM1 › Plastics piping systems - Polyethylene (PE) pipes for irrigation - Specifications - Amendment 1 (ISO 8779:2010/Amd 1:2014, IDT)
SS-ISO-8779-AM1
-
2010 EDITION AMENDMENT 1
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies the pipes (mains, sub-mains and laterals) with nominal outside diameters from 12 mm up to and including 63 mm made from polyethylene (PE) intended to be used for the conveyance of water for irrigation. It also specifies the general properties of PE and the test parameters for the pipes designated as PE 32 and PE 40 by checking referenced points as given in 4.4, to be used under the following conditions: - nominal pressures of PN 2,5, PN 4, PN 6, PN 8 and PN 10, as applicable, - at temperatures up to and including 45 ÂșC, as specified in Annex A. NOTE Pipes with a diameter of 75 mm and nominal pressure (PN) of 4 bar1) are also included in this International Standard.
To find similar documents by classification:
65.060.35 (Irrigation and drainage equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 8779:2010/Amd 1:2014
Revision Level
2010 EDITION AMENDMENT 1
Status
Current
Publication Date
July 4, 2014
Language(s)
English
Page Count
8
International Equivalent
ISO 8779:2010/Amd 1:2014(IDT)