Document Center List of Standards on Shafts
ICS Code 21.120.10
Return to ICS Index.Up to Level 2:
The following documents are a part of this series:
ASTM:
BSI:
- BS-4506 - Specification for shaft ends
- BS-4823 - Guide to the selection of fitment bores for cylindrical shaft ends
- BS-5186 - Specification for shaft centre heights
- BS-6102-14 - Cycles. Specification for dimensions of bottom bracket axle and crank assembly with square end fittings
- BS-7130 - Specification for mechanical balancing of rotating machinery: shaft and fitment key convention
- BS-ISO-10817-1 - Rotating shaft vibration measuring systems
- BS-ISO-21940-32 - Mechanical vibration. Rotor balancing
ISO:
Other SDOs:
- JIS-B-0902 - Driving and driven machines -- Shaft heights
- JIS-B-0903 - Cylindrical shaft ends
- JIS-B-0904 - Conical shaft ends for cone taper ratio 1:10
- SS-ISO-12667 - Commercial vehicles and buses - Cross-tooth propeller shaft flanges, type T
- SS-ISO-14 - Straight-sided splines for cylindrical shafts with internal centering - Dimensions, tolerances and verification
- SS-ISO-21940-32 - Mechanical vibration - Rotor balancing - Part 32: Shaft and fitment key convention (ISO 21940-32:2012, IDT)
- SS-ISO-6695 - Cycles - Pedal axle and crank assembly with square end fitting - Assembly dimensions (ISO 6695:2015, IDT)
- SS-ISO-7467 - Commercial vehicles and buses Cylindrical shaft ends and hubs for alternators