ASTM-A1006 Standard Specification for Steel Line Pipe, Black, Plain End, Laser Beam Welded (Withdrawn 2014)

ASTM-A1006 - 2000 R10 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification covers the standard requirements for laser beam welded, black plain end steel pipe for use in the conveyance of fluids under pressure. Dimensions and weight [mass] per unit length of pipes with designated NPS sizes and specified nominal wall thickness shall be given. Heat and product analysis shall be performed wherein steel shall conform to the required chemical composition for carbon, sulfur, and phosphorus. The steel shall conform to the required tensile properties such as minimum and maximum yield strength. The following tests shall be conducted, namely: Charpy V-notch test; weld ductility test; and hydrostatic test.

Scope

1.1 This specification covers laser beam welded, black, plain end steel pipe for use in the conveyance of fluids under pressure. Pipe in sizes NPS 1 to 26, inclusive, with nominal wall thickness 0.750 in. [19.1 mm] or less, as given in Table 1, is included. Pipe having other dimensions, in this size range, may be furnished provided such pipe complies with all other requirements of this specification.

1.2 It is intended that the pipe be capable of being circumferentially welded in the field when welding procedures in accordance with the requirements of the applicable pipeline construction code are used.

1.3 The values stated in either inch-pound units or in SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values in each system are not exact equivalents: therefore, each system is to be used independently of the other, without combining values in any way.

1.4 The following precautionary statement pertains to the test method portion, Section 14, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

black steel pipe; laser beam welded; line pipe; Laser beam-welded steel pipe; Plain end steel pipe--specifications; Black steel pipe--specifications; Welded steel pipe--specifications; ICS Number Code 23.040.10 (Iron and steel pipes)

To find similar documents by ASTM Volume:

01.01 (Steel--Piping, Tubing, Fittings)

To find similar documents by classification:

23.040.10 (Iron and steel pipes Steel pipes and tubes for specific use, see 77.140.75)

77.140.75 (Steel pipes and tubes for specific use Including hollow steel bars and sections for construction Steel pipes for conducting fluids, see 23.040.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-A1006/A1006M-00(2010)

Revision Level

2000 R10 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

Aug. 1, 2010

Document Type

Specification

Page Count

6 pages

Committee Number

A01.09