ASTM-A1007 › Standard Specification for Carbon Steel Wire for Wire Rope
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers uncoated and four classes of round, metallic coated, cold-drawn, carbon steel wire rope in five strength levels. The following materials testing procedures shall be conducted: standard tensile testing; alternate tensile testing; torsion testing; and wrap testing. The wire diameter tolerances of uncoated, drawn-galvanized or drawn-Zn5 Al-MM, and final-galvanized or final-coated Zn5 Al-MM rope wires shall be described. Minimum breakage forces for the carbon steel wire rope shall also be presented. During torsion testing, varying amounts of load shall be applied to the wire being tested.
Scope
1.1 This specification covers uncoated and metallic coated classes of round, cold-drawn, carbon steel wire for wire rope in five strength levels. This specification specifies:
1.1.1 Dimensional tolerances,
1.1.2 Mechanical characteristics,
1.1.3 Chemical composition requirements,
1.1.4 Coating requirements (if applicable), and
1.1.5 Packaging requirements.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
metallic coated; rope; wire;
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-E4Standard Practices for Force Verification of Testing Machines
ASTM-A510
Standard Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel, and Alloy Steel
ASTM-A153
Standard Specification for Zinc Coating (Hot-Dip) on Iron and Steel Hardware
Document Number
ASTM-A1007-22
Revision Level
2022 EDITION
Status
Current
Modification Type
Revision
Publication Date
Aug. 23, 2022
Document Type
Specification
Page Count
8 pages
Committee Number
A01.03