ASTM-A1039 › Standard Specification for Steel, Sheet, Hot Rolled, Carbon, Commercial, Structural, and High-Strength Low-Alloy, Produced by Twin-Roll Casting Process
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers commercial and structural steel sheet in coils and cut lengths produced by the twin-roll casting process.
1.2 The steel sheet is available in the designations listed in Section .
1.3 The material is available in the following sizes:
Thickness-0.027 in. [0.7 mm] to 0.078 in. [2.0 mm] |
Width-up to 79 in. [2000 mm] |
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other.
Note 1A description of the Twin-Roll Casting Process is included in Appendix X1.
Keywords
as-cast sheet; carbon steel sheet; commercial steel; hot rolled steel sheet; steel sheet; structural steel; ICS Number Code 77.140.01 (Iron and steel products in general)
To find similar documents by ASTM Volume:
01.03 (Steel--Plate, Sheet, Strip, Wire; Stainless Steel Bar)
To find similar documents by classification:
77.140.01 (Iron and steel products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A1039_A1039M-20
Revision Level
2020 EDITION
Status
Current
Modification Type
New
Publication Date
July 31, 2020
Document Type
Specification
Page Count
10 pages
Committee Number
A01.19