ASTM-A1041 Standard Specification for Pressure Vessel Plates, Alloy Steel, Higher Strength Chromium-Molybdenum-Tungsten (Withdrawn 2013)

ASTM-A1041 - 2004 R09 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This specification covers standard requirements for chromium-tungsten-molybdenum-vanadium, with or without tantalum, alloy steel plates intended primarily for welded boilers and pressure vessels designed for elevated temperature service. The steel shall be killed and shall conform to the fine austenitic grain size requirements. Heat and product analyses shall conform to the required chemical composition for carbon, manganese, phosphorus, sulfur, silicon, nickel, chromium, molybdenum, vanadium, boron, tantalum, and tungsten. The material shall undergo tensile test and shall conform to the required tensile properties such as tensile strength, yield strength, and elongation.

ORDER

Scope

1.1 This specification covers chromium-tungsten-molybdenum-vanadium, with or without tantalum, alloy steel plates intended primarily for welded boilers and pressure vessels designed for elevated temperature service.

1.2 Plates are available under this specification in two grades having different alloy contents as follows:

GradeNominal
Chromium
Content, %
Nominal
Tungsten
Content, %
Nominal
Molybdenum
Content, %
Nominal
Vanadium
Content, %
Nominal
Tantalum
Content, %
3153.001.500.750.25
315T3.001.500.750.250.10

1.3 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements.

1.4 The specification is expressed in both inch-pound units and in SI units; however, unless the order specifies the applicable M specification designation (SI units), the plates are furnished to inch-pound units.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Keywords

alloy steel plates; chromium; creep resistance; elevated temperature service; high-strength; hydrogen service; molybdenum; pressure vessels; tantalum; tungsten; vanadium, Chromium; Elevated temperature service applications--steel; Molybdenum; Pressure vessels; Tungsten; Welding/welds (pressure vessels); ICS Number Code 77.140.20 (Steels of high quality)

To find similar documents by ASTM Volume:

01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)

To find similar documents by classification:

77.140.20 (Stainless steels Including alloyed steels, corrosion-resistant steels, heat-resisting steels, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-A1041/A1041M-04(2009)

Revision Level

2004 R09 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

May 1, 2009

Document Type

Specification

Page Count

3 pages

Committee Number

A01.11