Document Center is acquired by Nimonik

Scope

1.1 This specification covers plain steel dowel bars with protective fusion-bonded epoxy coating for use in concrete pavements.

1.2 This specification is applicable for orders in either inch-pound units (as Specification A1078) or in SI units (as Specification A1078M).

1.3 The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with this specification.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—The coating applicator is identified throughout this specification as the manufacturer.

Keywords

coating requirements; concrete pavement; epoxy coating; steel dowels; ICS Number Code 21.060.99 (Other fasteners)

To find similar documents by ASTM Volume:

01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)

To find similar documents by classification:

21.060.99 (Other fasteners)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.