ASTM-A1119 › Standard Specification for Welded Partially Corrugated Tube for Potable Water and General Service
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification describes welded austenitic and duplex stainless steel tube on which the external and internal surface has been modified by a cold forming process to produce an intermittent corrugation for improved formability and resistance to seismic and other environmental distortions. The tubes are used for potable water service lines and other liquid delivery systems in nominal diameters from 1/2 to 2 in.
1.2 The tube sizes and thicknesses usually furnished to this specification are 0.625 to 2.125 in. outside diameter and 0.028 to 0.049 in., inclusive, in wall thickness.
1.3 The grades of austenitic, ferritic, and duplex stainless steels included in this specification shall conform to materials listed in the governing straight tube Specifications A268/A268M, A269/A269M, or A789/A789M. Selection will depend upon design and service requirements.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
austenitic stainless steel; duplex stainless steel; ferritic stainless steel; partially corrugated tube; stainless steel tube;
To find similar documents by ASTM Volume:
01.01 (Steel--Piping, Tubing, Fittings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A1119_A1119M-23A
Revision Level
2023A EDITION
Status
Current
Modification Type
Revision
Publication Date
May 10, 2023
Document Type
Specification
Page Count
8 pages
Committee Number
A01.10