ASTM-A202 Standard Specification for Pressure Vessel Plates, Alloy Steel, Chromium-Manganese-Silicon (Withdrawn 2004)

ASTM-A202 - 2003 EDITION - CANCELLED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for Pressure Vessel Plates, Alloy Steel, Chromium-Manganese-Silicon (Withdrawn 2004)

Scope

1.1 This specification covers chromium-manganese-silicon alloy steel plates, intended particularly for welded boilers and other pressure vessels.

1.2 Plates under this specification are available in two grades having strength levels as follows:

Grade Tensile Strengthksi [MPa]
A 75-95 [515-655]
B 85-110 [585-760]

1.3 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements; however, current practice normally limits the maximum thickness of plates furnished under this specification to 2 in. [50 mm].

1.4 Grade A is suitable for rivets and when so used the bars shall be subject to the requirements for rolled bars specified in Specification A 31, except for the chemical and mechanical requirements.

1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents. Therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.

Keywords

chromium; chromium-manganese-silcon; steel plates

To find similar documents by ASTM Volume:

01.04 (Steel--Structural, Reinforcing, Pressure Vessel, Railway)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

ASTM-G15
Standard Terminology Relating to Corrosion and Corrosion Testing (Withdrawn 2010)

ASTM-E8
Standard Test Methods for Tension Testing of Metallic Materials

ASTM-E29
Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

Document Number

ASTM-A202/A202M-03

Revision Level

2003 EDITION

Status

Cancelled

Modification Type

Withdrawn

Publication Date

Sept. 10, 2003

Document Type

Specification

Page Count

3 pages

Committee Number

A01.11